The Diecast Zone · Model Car Club Since 1994

Diecast Collector Forums

Eight forums, every scale, and thirty years of shop talk — new arrivals, restorations, reviews, and the finds you won’t see posted anywhere else, with the full archive back to 2002 restored and searchable. Free to Register.

8Forums
195,000+Topics
1,276,000+Posts
10,000+Members

Easy, (and crude) N...
 
Notifications
Clear all

[Closed] Easy, (and crude) New Yorker fix. Put the car upside down

2 Posts
1 Users
0 Reactions
10 Views
(@Larry Churchill)
Joined: 1 second ago
Posts: 0
 

Easy, (and crude) New Yorker fix. Put the car upside down in its package. Unscrew the back bumper. Unscrew the four other screws around the bumpers. Lift the chassis out. Unscrew the little screws above the rear axle. Put something in the screw space to act as a washer(anything). I used a lid top from a plastic storage container cut to about 1/4inch square (with scissors)with a tiny hole drilled in it. Use the screws that were adjacent to the front bumper (you're going to move them back to the rear axle) and reattach. Use the screws that were originally over the rear axle to reattach to the front bumper. I am thinking that on this issue, the screws between the front end and the rear axle may have been mixed up. However, do these steps and it will please you very much!!!!!



   
(@Ted Slezak)
Joined: 1 second ago
Posts: 0
 

Thanks

Thanks for the instructions!

They certainly are simple enough and I do have small washers that I can use as spacers.

Apparently the chassis will just lift out with the screws removed. Why it won't on my 300C coupe is now a mystery.

You may be right about the screws getting mixed up, but it doesn't say much for the vendors quality control if they didn't catch it early on. If they had a finished picture of the car to go by it should have been obvious there was a problem.



   
Share: