Notifications
Clear all
The Lounge
6
Posts
2
Users
2
Reactions
748
Views
Topic starter
31/01/2021 9:27 am
I'm trying to take apart this Danbury Mint model. The glue seems "superglue" strength. Any suggestions?
John Kuvakas and John Kuvakas reacted
31/01/2021 9:33 am
do you have a CA glue remover on hand that you might try in a discrete area?
Topic starter
31/01/2021 12:04 pm
Sorry, John, but I don't. I looked for one at my local Lowe's yesterday and they had nothing in stock.
31/01/2021 12:39 pm
ok.....I am not certain if the pewter line uses a Cyanoacrylate type of "super glue" (CA).....but if they do,here`s a very good product for dealing with CA glue....I would wait to hear from the pewter crowd,in case a different type of glue is used for pewter cars
Bob Smith Industries BSI-161H UN-CURE Super Glue Debonder, 1 oz.,Clear
Topic starter
31/01/2021 1:22 pm
Thank you, John. This debonder sounds like just what I need. I have ordered it. I appreciate your recommendation. David
31/01/2021 4:31 pm
I hope it works as needed for you David......make sure to seal the jar tightly after using......it has penetrating and leeching properties similar to WD-40....I`d put a few drops on a glue joint,wait 60 seconds or so,check for movement of the glue weld like you would a loose tooth.....this process can be repeated as needed multiple times....3 times has been the upper limit for me